The alarms with the exact wording as listed are supported. Any alarms with a different wording will not be recognized by the Data Center Operation: PRO Pack.
However, it is possible to customize the critical alarm and threshold configuration for migration of impacted servers.
APC/MGE UPS
|
- The battery power is too low to continue to support the load; the UPS will transfer to Bypass. The load will be powered by Bypass AC.
- The battery power is too low to continue to support the load; the UPS will shut down if input power does not return to normal soon.
- The battery power is too low to support the load; if power fails, the UPS will be shut down immediately.
- Lost the management interface-to-UPS communication while the UPS was on battery.
- The load exceeds 100% of rated capacity.
- A battery fault exists.
- On battery power in response to an input power problem.
- The UPS failed its diagnostic self-test, due to either an overload or poor battery health.
Symmetra MW:
- Alarm low battery warning.
- Alarm Overload.
|
Liebert
|
- The system has detected an overload condition.
- The system has performed an emergency transfer to bypass.
- This system has detected an overload condition.
- This system has detected Output to Load is in an overload condition.
- This system has detected Output overload condition.
- The system has detected a self-test failure.
- Overload error present on at least one phase of static bypass switch.
- The battery capacity is low.
- The system has detected a battery low shutdown error.
|
APC Coolers
|
InRow RC:
- Cooling failure exists
- Condensate pan full fault exists
- On standby, input contact fault exists
InRow RD:
- A cooling failure exists.
- A unit type conflict alarm exists.
InRow RP:
- Cooling failure exists.
- On standby, an input contact fault exists.
- High discharge pressure alarm exists.
- Compressor drive fault exists.
InRow SC:
- Cooling failure exists.
- A persistent high discharge pressure alarm exists.
- A persistent low suction pressure alarm exists.
- A startup low suction pressure alarm exists.
- A startup line pressure imbalance alarm exists
- On standby, an input contact fault exists.
|
0 comments
Please sign in to leave a comment.